Wiring - Harley Sub-Harness 1997-2013

WIRING IS NOT RETURNABLE!!!! NO EXCEPTIONS!!!!

HARLEY SUB-HARNESS

You will Also need:

Part# 99607660 Isolator 

Part# 99702000 4 Ft Harness

Description

Isolators easily and properly connect the lighting from your trailer, sidecar, trike, etc. while removing the electrical load from the motorcycle's factory wiring, fuses, relays, computers and electronics. Proper isolation of electrical loads will help you to not void any factory warranty.

Our design is a modular daisy chain of a separate sub-harness, modules and the Isolator. The advantage is that you can accommodate a 5 wire trailer, a 4 wire trailer, or swap sub-harnesses should you sell your current bike. All our electronics are made in the USA.

Sub-Harnesses
The sub-harness connects to your bike on one end and the Isolator on the other.
This makes the connection “Plug & Play” so you don’t have to splice.
There are 3 sub-harness versions used from the late 90s until 2013:

If your bike is:
2010-13 FLTRX
2010-13 FLHX
These 2 bikes use the 6 pin Molex – Part# 99607682

2009-13 FLTRSE
2010-13 FLHXSE
These 2 bikes use the 8 pin Molex –Part# 99607673

If your bike is not one of the 4 listed above, you will use AMP Connector – p/n 99607667

1997/2013 FLST (all except SE)
1997/2013 FLHT (all)
1997/2011 FLHR (all except SE)
2006/09 FLHX
1997/2008 FLT & FLTR
2011/13 FLTRU
2011 FLTRUSE

Isolator
The isolator is the main component. And ours is made in the USA. Tennessee to be exact.
Ours are epoxy potted for weather resistance using Omron components (Omron is an OEM supplier to most all the major automotive and motorcycle manufacturers).
We use the best component available for the job; in fact, Toyota uses the same component for power window switching.

Trailer Light Converter (5 to 4 module)
If your trailer is a 4 wire setup (has combined brake and turn signals), you will need this converter.